4024-110
FINISHER TESTS
Staple Test
This test verifies the staple mechanism by sending eight sheets of media from the printers default paper source
and stapling the sheets.
To run the Staple Test:
1.
Select FINISHER TESTS from DIAGNOSTICS.
2.
Select Staple Test from FINISHER TESTS.
3.
Select the output bin and press
While the test runs the power indicator blinks and the message Staple Test Running... displays.
Select.Stop (
Hole Punch Test
This test is used to verify whether or not media can be fed to a finisher output bin and punched. Eight sheets of
blank paper are fed from the default paper source and fed to the finisher output bins. Letter size paper is used for
the 3 hole test and A4 media is used for the 4 hole test. Media is selected from the default tray.
To run the Feed Test:
1.
Select FINISHER TESTS from DIAGNOSTICS.
2.
Select Feed Tests from FINISHER TESTS.
While the feed test runs the power indicator blinks and the message Feed Test Running... displays.
During the test, no buttons are active and the test cannot be stopped until the test is completed.
Feed Tests
This test is used to verify whether or not media can be fed to a finisher output bin. Eight sheets of blank paper
are fed from the default paper source and fed to the finisher output bins.
Note: This test can be run using any of the paper sizes supported by the printer.
To run the Feed Test:
1.
Select FINISHER TESTS from DIAGNOSTICS.
2.
Select Feed Tests from FINISHER TESTS.
While the feed test runs the power indicator blinks and the message Feed Test Running... displays.
During the test, no buttons are active and the test cannot be stopped until the test is completed.
Sensor Test (finisher)
This test can be used to verify whether or not the finisher sensors are working correctly.
To run the finisher Sensor Test:
1.
Select FINISHER TESTS from DIAGNOSTICS.
2.
Select Sensor Test from FINISHER TESTS.
3.
Select one of the test categories:
•
Cover and Door
•
Bin Level
•
Media Path1
•
Media Path2
•
Punch and Staple
3-2
Finisher Service Manual
.
) to exit the test before it completes.