Logik L19DVDP10 Quick Start Manual

19" HD Ready Digital LCD TV
With DVD Player
Quick Start Guide
L19DVDP10
L19DVDB20
Congratulations
on the purchase of your new Logik TV.
Your new TV incorporates the latest technology to enhance your viewing experience.
We would suggest that you allow about 20 mins for initial setup.
Please follow this guide for a successful rst time installation.
1 1

Unpacking

Remove all packaging from the TV. Retain the packaging. If you dispose of it please
do so according to any local regulations.
LCD TV with Remote Control / Mains Cable
TV Stand Support AAA Batteries x 2
TV Base Stand Screw A x 1
Instruction Manual Quick Start Guide
2 2

Installing the Base Stand

Screw A x 1
part number I.03.TW3012A01
1. Lay the TV down on a at surface with the back side facing up. Please make sure to
place a soft cushioned material (such as a pillow or thick piece of foam) beneath the
screen.
2. Attach the base stand until the screw holes are aligned. Secure the base stand with
the supplied screw A.
3 3

Operating Your Remote Control

1. Press and lift the back cover
up to open the battery
compartment of the remote
control.
2. Insert two AAA size batteries.
Close the battery
compartment cover.
Install the batteries correctly by following the polarity (+ and -) indications
in the battery compartment.
AV Cable
R
4 4
Video
L

Connecting the Aerial

Video R L
OR
RF coaxial cable
(not included)
Digital Switchover
Addendum
Connect one end of the RF coaxial cable to the aerial socket on the wall and the
other end of the cable to the RF (75 ) socket at the right rear side of your TV.
Do not connect the TV to the mains supply until you have completed all
the connections.
1
2
CARD FACE FRONT
5 5

Connecting to the Mains Socket

ON OFF
To mains socket
1. Connect the supplied mains cable to the AC~ socket at the back of your TV and
then connect it to the mains socket after you have completed all the connections.
2. Switch on the POWER ON/OFF at the side of the TV. At this stage, the TV switches
to standby mode. The red LED indicator will illuminate on the front panel of the
TV.
3. Press the button on the top panel of the TV or the
control to turn the TV on. The red LED indicator will turn blue.
6 6
Turning the TV on for the first time
The first time you turn the TV on, it will go straight into First Time Installation.
Press the OK button on the remote control to start the First Time Installation.
Well done,
your new TV is now ready to use.
You will nd that there are many exciting features available. To get to know all these
features, please take some time to read the instruction manual provided with your TV.
button on the remote
(P.N.: I.08.015197718)