Qvis MINI-PTZ-23X-H User Manual page 25

Note:
 For security reasons, please set privacy zone a little bit larger than the privacy object size.
 Each time, after modifications you need to move the cursor to SAVE button and then click confirm button
to get all setup activated. Otherwise, privacy zone may not move correspondingly with the object.
2. Please enter privacy mask menu.
3. Move the cursor to PRIVACY NO, please use left/right key to set different privacy zones.
4. For example, shift to 001 section and then move the cursor to SETTING.
5. Secondly, click OK button to go to the setup interface. Now there is a privacy zone in the screen centre.
Operate PTZ to move the camera screen so that the centre of the object you want to shield is overlaying
with the centre of the screen.
6. Thirdly, move the cursor to RESIZE and then click left and right key to adjust privacy zone direction and
size.
7. Fourthly, move the cursor to SAVE and then click confirm button to exit. Please note you need to click
SAVE button to save current privacy mask setup so that the privacy mask region can move along with
the PTZ movement to always cover the object you want to shield.

PRIVACY NO：This is to set the privacy mask zone. Please use the left/right button on the keyboard or in
the speed dome terminal menu to set. You can call corresponding privacy mask zone numbers if you have
successfully set one up.

PRIVACY MASKING: There are two settings: on and off. Please go to the corresponding privacy mask zone
and click left/right button to set.

RESIZE：This is to adjust the privacy zone size. Move the cursor to current item and use the left/right
button on the keyboard or in the speed dome terminal menu to set .Please continue pressing direction
button to widen or narrow zone size. ← is to narrow the horizontal width and → is to widen the horizontal
width. ↑ is to widen vertical height and ↓ is to narrow the vertical height.

SAVE：Here is to save user setup.

BACK: Go back to previous menu.

EXIT: Log out system menu.
Power Up
Move the cursor to the POWER UP item and then click the confirm button, you can go to the fourth menu.

POWER UP: It is to set the PTZ operation when the speed dome boots up. The option includes:
NONE/AUTO/SCAN/PRESET/PATTERN/TOUR. Please use the left/right button to set.
：AUTO
POWER UP
：OFF
PARAMTER
BACK EXIT
18