Page 1
Focal Point Fires plc. You are not per- mitted to copy or adapt any of the content without the prior written permission of Focal Point Fires plc.
If fitted into an open draught fireplace, it is advisable to blank off the chimney to reduce the risk of draught through the fire, which may cause the safety cut out system in the fan heater to operate. 2013 Focal Point Fires plc.
If the sequence has been followed correctly and the heaters still fail to function, check the power supply cable plug is plugged in at the outlet socket. If this is not the cause, call an electrician. 2013 Focal Point Fires plc.
Once you have fitted the screws in place, offer the fire up to the hearth and lift the fire by a small amount to locate the two keyhole slots on the back of the fire over the screws. When you lower the appliance, it will now be locked in place. 2013 Focal Point Fires plc.
Page 5
Step 2: Remove the four screws from the rear spacer located at the rear of the appliance. Step 3: Remove the outer spacer frame. Step 4: To remove the second spacer by repeating steps 1, 2 & 3. 2013 Focal Point Fires plc.
The LED light strip is designed and tested to last. 20,000 hours however, should a problem occur with the LED light strip this can be replaced. The LED light strip can be purchased from Focal Point Fires (please see contact details on front cover).The light strip will be supplied with fit- ting instructions.
Page 7
3G Service Department to the address below. Alternatively, you can email or fax.Please note that this does not affect your statutory rights. Focal Point Fires plc, 3G Service Department, Reid Street, Christchurch, Dorset, BH23 2BT. Alternatively email: 3g@focalpointfires.co.uk or fax. 01202 499326.
Need help?
Do you have a question about the Blenheim and is the answer not in the manual?
Questions and answers