Remote Control Operation; Transmitter; Temperature Display; Key Lock - kozy heat CSK-29-G Installation And Operation Manual

PROFLAME 2 TRANSMITTER
BLUE BACK
LCD DISPLAY
ON/OFF KEY
THERMOSTAT KEY
UP/DOWN ARROWS
MODE KEY

11.8 Remote Control Operation

11.8.1 Temperature Display

1. With the system in the OFF position, simultaneously press the
thermostat key and the mode key to change degrees from °F
to °C.
2. Visually check the LCD screen to verify either °F or °C is
displayed on the right side of the room temperature display.
SYSTEM OFF

11.8.2 Key Lock

This function locks the keys to avoid unsupervised operation.
Once activated, a lock icon will appear on the LCD screen.
1. Simultaneously press the mode key and the up arrow key to
activate or deactivate this function.
TRANSMISSION
THERMOSTAT
OFF/ON/SMART
SET POINT
TEMPERATURE/LEVEL/STATE
FLAME ON
FAN
11.8.3 Pilot Ignition Selection (IPI/CPI)
This system has the option of a continuous (standing) pilot. This
features allows the system to change from a spark-to-pilot system
to the standing pilot option. The standing pilot will keep the firebox
warm and establish a draft in the vent, which allows the main burner
to ignite with less air-flow disruption.
When the system is OFF, the LCD screen will display the snowflake
icon during the setup of either IPI or CPI mode. To select the
preferred pilot ignition feature,
1. With the system in the OFF position, press the mode key to
index the CPI mode icon.
2. Press the up arrow key to activate CPI.
3. Press the down arrow key to return to IPI. A single 'beep' will
confirm reception of the command.
When the system is ON,
IPI mode: LCD screen will not display the snowflake icon
CPI mode: LCD screen will display the snowflake icon
SYSTEM OFF
LCD DISPLAY
KEY LOCK
LOW BATTERY ALARM
LIGHT ON
OPERATING INSTRUCTIONS 27
ROOM
TEMPERATURE
CPI MODE
SPLIT FLOW