TFA WIRELESS 433 MHz TEMPERATURE STATION Instruction Manual page 40

1. Fix a screw (not supplied) into the desired wall, leaving the head extended out
by about 5mm.
2. Away from the base and hang the station onto the screw. Remember to
ensure that it locks into place before releasing.
POSITIONING THE OUTDOOR TRANSMITTER
The outdoor transmitter is supplied with a holder that may be attached to a wall
with the screws supplied. To attach to the wall using screws, please follow the
steps below:
1. Mark the wall using a pen through the holes in the holder to
obtain the exact drilling position.
2. Drill holes in the wall at the points marked.
3. Screw holder onto wall.
The mounting surface can affect the transmission range. If e.g. the unit is
attached to a piece of metal, it may either reduce or increase the transmitting
range. For this reason, we recommend not placing the unit on any metal
surfaces or in any position where a large metal or highly polished surface is in
the immediate proximity (garage doors, double glazing etc.). Before securing in
place, please ensure that the temperature station can receive the signal from the outdoor transmitter at the
positions that you wish to situate them.
87