Table of Contents
Advertisement
3.
Press Plus to get in Learn/ Remove setting of channels. The channel icon "1" will be flashing.
4.
Press OK key ( ) to select another channel, if necessary (1-5).
5.
Press Plus to set the selected channel to "Re-learn" state (The channel icon will flash in two places
on the display), or press Minus to remove the channel (The channel icon will disappear).
6.
As soon as the in two places flashing channel number disappears, the reception icon will be flashing
in the top left corner. Insert the batteries in the respective transmitter.
After a short time (1 minute at the maximum) the transmitter should be linked.
7.
Repeat the above steps for further channels, if necessary.
Note:
Once a channel is removed, the temperature station will be "disconnected" form the channel and
the data transmitted by this channel cannot be viewed at the temperature station.
THE NUMBER OF OUTDOOR TRANSMITTERS TO BE SAVED INTO THE SYSTEM
MEMORY
Digits flashing
69
Advertisement
Table of Contents
