Table of Contents
Advertisement
1.
Press and hold the OK key until the digits "Lcd" starts flashing.
2.
Press and release the OK key eleven times to enter minute setting of the recoding interval. The min
in the record LCD will be flashing.
3.
Use the Plus and Minus key to set the desired recording interval.
4.
Press the Mode or Alarm key to confirm and go back to the normal display mode.
LEARNING/ REMOVING A TRANSMITTER (CHANNEL)
After replacement of batteries of a particular transmitter, it is necessary to learn the transmitter again in the
learning mode. On the other hand, when user wants to decrease the number of transmitters to be applied,
he may remove the transmitter so that the data from this channel will not be displayed in the temperature
station. The below procedures describe how to "re-learn" or "remove" a channel:
1.
Press and hold the OK key until the digits "Lcd" starts flashing.
2.
Press shortly the OK key twelve times to enter Learn/ Remove setting of channels. The digits "Lrn",
"CH" and the channel icons will be flashing.
Flashing
Digit flashing
68
Advertisement
Table of Contents
