Uploading Saf-Te Controller Card Firmware - Gateway 850 User Manual

Uploading SAF-TE controller card
firmware
The following information describes the procedures to upload new firmware
to the SAF-TE controller card. The firmware can be uploaded in a "live"
environment. There is no need to turn off the enclosure to perform this
function.
To upload new firmware:
1
Connect one end of the null-modem RS-232 cable to the SAF-TE Service
port located on the rear panel of the enclosure.
SAF-TE Service Port
The cable is a DB-9 null-modem serial cable.
2
Connect the other end of the cable to either a host system's serial
communication port or a VT-100-type terminal.
3
On a host system, run a terminal emulation program or start the terminal.

Uploading SAF-TE controller card firmware

www.gateway.com 41