One-Touch Annunciation - Gateway 850 User Manual

One-touch annunciation

The "one-touch annunciation" monitoring system is an easily accessible
press-to-touch display of the SAF-TE card switch settings, enclosure bus mode,
type of host interface, serial communication BAUD rate, and controller status
using the Drive Status LEDs and the Alarm Reset button.
By pressing and holding the Alarm Reset button, the Drive Activity LEDs will
all be off and the Drive Status LEDs will turn on in unique combinations to
designate certain enclosure conditions. Below is a table that describes the Drive
Status LEDs and their meanings:
One-touch annunciation - drive status LED interpretation table
Drive Slot 1 Status
LED
Bus Configuration
On = Dual Bus
Off = Single Bus
Drive Slot 2 Status
LED
Host Interface Type
On = SCSI Host
OFF = Fibre Host
Drive Slot 3 Status
LED
Not Applicable - Not
used.
Enabled condition equals an UP switch position.
Disabled condition equals a DOWN switch position.
Drive Slot 4 Status Drive Slot 7 Status
LED LED
Switch 1 - SCSI IDs Switch 2 - SCSI IDs
(A0) (A1)
On = Enabled On = Enabled
Off = Disabled Off = Disabled
Drive Slot 5 Status Drive Slot 8 Status
LED LED
BAUD Rate - Switch Delay Start - Switch
6 7
On = 19,200 BAUD On = Delay Start
Disabled
Off = 9,600 BAUD
Off = Delay Start
Enabled
Drive Slot 6 Status Drive Slot 9 Status
LED LED
Not Applicable - Not Controller 1 - (CTRL
used. A)
On "GREEN" =
Good
Off = Not Installed
On "ORANGE" =
Failed
www.gateway.com
Enclosure component monitoring
Drive Slot 10 Status
LED
Switch 3 - RAID
Addressing (RD)
On = Enabled for RAID
Off = Disabled for JBOD
Drive Slot 11 Status
LED
Remote Start - Switch 8
On = Remote Start
Disabled
Off = Remote Start
Enabled
Drive Slot 12 Status
LED
Controller 2 - (CTRL B)
On "GREEN" = Good
Off = Not Installed
On "ORANGE" = Failed
35