Table of Contents
Advertisement
10
Install the drives.
a
Remove each drive from its shipping container and inspect each drive
for obvious damage.
b
From the front of the storage enclosure, install each drive into its drive
slot.
Align the carrier rails with the rail grooves in the drive bay. The drive
carrier tension clips ensure that the drive fits very tight, so it requires
some force to push the drive into its bay. Make sure that the drive
seats completely. Repeat this step to populate all the drive slots.
c
Reinstall the front bezel. Make sure that the bezel mounts to the two
stud posts and the bezel lip fits under the chassis top.
Secure the front bezel by rotating the thumbscrews clockwise
one-quarter turn.
11
Install the power cords and secure them using the power cord clips.
Warning
Make sure that the power supply On/Off switches are in
their Off position.
www.gateway.com
Enclosure detailed installation
19
Advertisement
Table of Contents
