Table of Contents
Advertisement
Enclosure detailed installation
This first section describes preparing and installing the enclosure into the rack
cabinet.
After installing the hardware components, go to "Enclosure configuration" on
page 21 and set the SAF-TE Disk I/O card switches and enclosure cabling for
your drive configuration.
Installing the storage enclosure in a rack
cabinet
To install the storage enclosure in a rack cabinet:
1
Select an appropriate location within your rack cabinet. If you are installing
more than one enclosure, you should consider the location of the
enclosures in relationship to each other to make sure that the cables will
easily reach between enclosures.
Warning
Make sure that the selected location in the rack cabinet has adequate air
flow for the front-to-side and side-to-side areas.
2
Remove the enclosure from its shipping carton and inspect for obvious
damage. Place the enclosure on a flat surface.
The power supplies and drives should be removed prior
to installing the enclosure into the rack cabinet. The
enclosure chassis could be damaged during installation
due to the added weight of the power supplies and drives.
www.gateway.com
Enclosure detailed installation
15
Advertisement
Table of Contents
