Gateway 850 User Manual page 22

Chapter 2: Setup and Installation
d
e
Rear Rack Vertical Post
Nut
Nut
9
Re-install the power supplies. Do this by aligning the power supply with
its open bay and sliding the power supply in.
Make sure that the power supply completely seats in the enclosure. The
power supply will fit flush and the latch will reset as the power supply
reaches its fully seated position.
18
From the rear of the rack cabinet, slide one of the mounting rails into
the slot provided on the left side of the enclosure.
Push the rail into the slot until it fits the depth of the rack cabinet.
It should mate with the rear rack cabinet vertical post.
Make sure that the enclosure is level. Do this by verifying that the
same height mounting location slots on both the front and rear rack
cabinet vertical post are being used.
Secure the left side rail to the vertical post using the screws and nuts.
Repeat the substeps 8(c) and 8(d) for the right side rail.
Rail Slot
Mounting
Screws
www.gateway.com
Rail Slot