Table of Contents
Advertisement
Chapter 2: Setup and Installation
a
b
c
12
Repeat the above steps for each additional enclosure you are installing.
Before you continue...
The next section includes steps and diagrams for setting the SAF-TE Disk I/O
card switches and attaching the required SCSI data cables for each drive
configuration. Locate the applicable configuration and refer to the steps and
diagrams to set the card switches and cable your system.
The last section of this chapter provides the steps to correctly turn on or off
your enclosure.
20
Make sure that the orientation is such that when the power cord is
inserted, the clip will be at the top of the cord and will fit over and
onto the cord.
Connect the other ends of the power cords into three-hole grounded
outlets or a UPS power system.
Repeat steps 10(a) and 10(b) for the other power cord.
www.gateway.com
Clip fits over
and onto the
power cord.
Advertisement
Table of Contents
