6. CONNECTING EXTERNAL TIME SIGNAL
Follow the steps below to connect an external time signal device.
Screw
1
Unscrew the screw fixed on the
bottom of the unit to remove the
cover plate.
3
Insert wires into Terminals while
pushing upper part of Terminal Block
with screwdriver, then tighten both
screws of cable clamp.
Connection Specifications for External
Contact
Cover Plate
2
Feed wires through clamp. Do not
tighten clamp screws.
Channel
4
Fold down Cover Plate and secure
with screw.
Route Power and Bell
wires through Channel in base of clock.
Maximum of 8 bells/horns (typical)
8
28