Geofence Zones Settings And Parameters; Geofence Border Width (Id=20); Geofence Zone #1 Configuration Parameter (Id=30); Geofence X1 (Id=31) - Teltonika FM2200 User Manual

8.5

Geofence zones settings and parameters

This chapter explains how to get all parameters for the first GeoFence zone (all ID numbers are
st
for the 1 zone). And at the end of the chapter (part 1.6.7) is presented a table with the IDs of all the
rest GeoFence zones.

GeoFence border width (ID=20)

Minimum Maximum
value value
100 9999999

GeoFence Zone #1 Configuration Parameter (ID=30)

GeoFence Zone #1 Configuration is 1
priority, zone entering event, zone-leaving event. There are two GeoFence zone shapes: circle,
rectangle. GeoFence Zone priority has eight levels (0 to 7). Parameter value is four bytes that have bit
encoded values.
0 bit – GeoFence zone shape
1-3 bits – GeoFence event priority
4 bit – Zone entering event
5 bit – Zone leaving event
6-31 bits reserved
Example:
Value to set: 51 (integer) is [M]00110011[L], where GeoFence Zone shape is Rectangular,
priority of 1, Zone entering event is enabled, Zone leaving event is enabled.
Minimum Maximum
value value
0 -

GeoFence x1 (ID=31)

Parameter has two meanings dependent on zone shape. If shape is rectangular, then ID=31 is
left down corner X coordinate in WGS. If shape is circle, then ID=31 is center of that circle X
coordinate in WGS.
Sample value: 25.30528
Minimum Maximum
value value
-180.0 180.0

GeoFence y1 (ID=32)

Parameter has two meanings dependent on zone shape. If shape is rectangular, then ID=32 is
left down corner Y coordinate in WGS. If shape is circle, then ID=32 is center of that circle Y
coordinate in WGS.
GeoFence border thickness, measured in meters.
Recommended
Goes with (depends on) parameters
value
GeoFence Zone #1 Configuration
1000
st
zone basic settings parameter: GeoFence zone shape,
Recommende
Goes with (depends on) parameters
d value
GeoFence border width (ID=20)
-
Recommended
Goes with (depends on) parameters
value
GeoFence border width (ID=20)
- GeoFence Zone #1 Configuration
Parameter (ID=30)
GeoFence x1 (ID=31)
GeoFence y1 (ID=32)

GeoFence x2 (ID=33)

GeoFence y2 (ID=34)

Parameter (ID=30)
Value type
U32
Value type
U32
Value type
Float
39