Configuring Wireless Lan Setting And Security Setting - Sanyo PLC-WXU700A Owner's Manual

Configuring wireless LAN setting and security setting

Configure the wireless LAN setting and security setting for Wireless 4 and Wireless 5.
Configuring wireless LAN setting
1. Click page [2] of setting pages. Following wireless LAN setting can be done. After completing the
configuration, press Set button.
Item
Wireless Mode ........Select the Communication standard 802.11b, 802.11b/g or 802.11b/g/n.
Network Type..........Select either "Infrastructure" or "AdHoc". When selecting the "AdHoc", the
SSID/ESSID ...............Set the SSID/ESSID. (up to ASCII 32 characters)
Channel.....................If you use the projector in 802.11AdHoc mode, select the channel, from 1 to 11.
When selecting the "AdHoc" in Network Type, the Wireless Mode is used "802.11b/g" even if
"802.b/g/n" was selected.
Notes for entering characters:
The "¥" symbol is displayed as "\" when the ASCII key is used. The " " symbol is treated as a character
by the ASCII key, but it is not interpreted as a character by the HEX key. In HEX, the " " symbol is
displayed in red and setting is denied.
You can not set all the characters with the " " symbol. It will be considered as no operation.
ASCII key characters : Space - 0 to 9 A to Z a to z ! " # $ % & ' ( ) * + , . / : ; < = > ? @ [ ¥ ] ^ _ ` { | } ~
HEX key characters : 0 to 9 a to f
Description
security "WPA-PSK" and "WPA2-PSK" mode are not available.
SSID/ESSID is case-sensitive. Even though all characters on the Wireless
information is uppercase, it is necessary to distinguish between upper case and
lower case characters.
Configuring wireless LAN setting and security setting
55