Sanyo PLC-WXU700A Owner's Manual page 295

Chapter 6 Basic setting and operation
Configuring wireless LAN security setting
Click page [3] of setting pages. Following wireless LAN security
setting can be done. After completing the configuration, press
Set button.
Item
Network security ...Sets the type of encryption. Following types are available.
Input type.................ASCII or HEX. See item "Notes for entering characters"
Key index1 - 4..........Enter keys of encryption.
PSK..............................Available when the "WPA-PSK(TKIP)" or "WPA2-PSK(AES)" is selected.
56
Description
WEP64(40)bit Open
WEP64(40)bit Share
WEP128(104)bit Open
WEP128(104)bit Share
WPA-PSK(TKIP)
WPA2-PSK(AES)
The used number of character changes as the table below according to the type
of WEP encryption and input type.
WEP option
WEP64(40)bit ASCII
WEP64(40)bit HEX
WEP128(104)bit ASCII
WEP128(104)bit HEX
Four
key indexes can be set, however, the only one with check on its radio
button is effective. Both of the number and value of the key index in effect must
be same as those of your computer and the access point.
Depending on computers and access points, you may be allowed to select only
one WEP key. In that case, use key index1.
The PSK key must be no fewer than 8, nor more than 63 digits with ASCII code,
and 64 digits with Hex code.
Characters
5 characters
10 characters
13 characters
26 characters