Use Of Telnet - Sanyo PLC-WXU700A Owner's Manual

Chapter 11 Appendix

Use of telnet

You can control the projector by using the telnet application
the telnet application is available on your computer.
* The telnet 10000 port is used to control the projector.
Control
(For example, in case of using the telnet application of the Windows XP Professional.)
1. Select Run... submenu from Start menu on the computer. Type "telnet" onto the Open text area on
the displayed window and press OK button.
2. The telnet application will start and the following window will be displayed. Type as below to
connect the projector.
> open_192.168.1.201_10000 [return]
* Use the IP address assigned to the projector
3. When communication is established correctly, the word "PASSWORD:" appears on the window.
Type the login password (Network PIN code
keyboard. If you do not set up the Network PIN code, just press "Enter" key.
When the word "Hello" is replied, login has been succeeded.
* The password "1234" is used for the example.
138
installed on your computer. Normally,
*1
) for the projector and then press "Enter" key on the
*2