Sanyo PLC-WXU700A Owner's Manual page 309

Chapter 7 Controlling the projector
Image adjustment
This function is to adjust the projected picture image and save the image mode. To store the adjusted
value, click Store button, and to load the adjusted value, click Load button.
Input source
Image mode Video
Dynamic
Standard
Real
Cinema
Blackboard(Green)
Colorboard
Image 1 - 4
70
Item
Contrast.....................Adjusts picture contrast
Brightness ................Adjusts picture brightness
Color...........................Adjusts picture color saturation
Tint..............................Adjusts picture hue
Item
Color temp. ..............Sets a color temperature mode.
White balance
Red, Green,
Blue ......................Adjusts each white balance respectively.
Sharpness.................Adjusts picture sharpness.
* When the value of the white balance is changed, the color temp. indicates
"Adj."
Item
Gamma........................ Adjusts brightness of darker part of the picture.
Noise reduction ....... Switches noise reduction mode
Progressive.................. Switches progressive mode
Reset...........................Resets the Image adjustment to previous levels.
Store...........................Stores the Image adjustment values. Select an item
Load............................Loads the Image mode.
Computer
*
*
The mark " " indicates the available image mode in the selected input
source. The error message appears when the disabled image mode
indicated with "*" is selected.
Description
Description
Description
[Image 1 - Image 4] from the pull-down menu and click
Store button.
Select an image mode from
the pull-down menu and
click Load button. There may not be available mode
depending on the input
mode as shown in the table
left.