Easy Wireless Setting - Sanyo PLC-WXU700A Owner's Manual

Easy wireless setting

With this setting, you do not need any complicated LAN setting procedures.
The network type will be AdHoc mode.
CAUTION: This function can be used only when logged in by Administrative right. The using network
adaptor should be "AirMac".
Setting Procedures
1. Turn on the projector and select "Network" in the Input menu of the projector.
2. Select "LAN mode select" in the Network menu and press SELECT button.
3. Select "Wireless Simple" with the Point
message will appear and switching operation will start. Switching will take a while and after
completing the operation the message "Ready for use" will appear. During the switching period, the
projector cannot be operated. ("SIMPLE" LAN settings will be shown by pressing SELECT button. The
settings cannot be changed.)
4. Activate "Network Capture 5" which is installed in the computer.
5. Authentication window will appear. Type your Name and Password and then click OK button. The
Wireless LAN setting screen will appear and the computer will start to set up the Wireless LAN
setting. (Adjust the computer's Wireless LAN environment to the "SIMPLE" setting LAN environment.)
After completing the settings, the computer will start searching the projector which was set as
"SIMPLE" and will display the name of the projector or the IP address on the projector list.
Confirm whether the LAN has been set correctly and works properly. Refer to "4. Wired LAN
configurations" "Confirming the operation" (p.30) for the confirmation procedures.
If the network setup is not succeeded, the error screen will appear.
You can also set the easy wireless setting by clinking the Wireless easy setting button.
Setting screen
* The projector should be set up previously to complete the easy wireless setting.
buttons. Press the Point button then the "Please wait... "
Wireless easy setting button
Easy wireless setting
Error Screen
41