Roland VersaEXPRESS RF-640 User Manual page 123

An Error Message Appears
[AVOIDING DRY-UP TURN POWER OFF]
The print-head carriage was forced to move to the standby position to prevent the print
heads from drying out.
Operation cannot be continued. Switch the sub power off, then back on.
[SET HEAD HEIGHT TO . . .]
The height of the print heads is lower than the height specified on the software RIP.
This warning indicates that the height of the print heads is too low for the media thickness specified on the
software RIP. The print-head carriage moves to a location where you can operate the height-adjustment lever.
Adjust to the displayed height, then press .
 P. 87, "Adjusting Print Head Height to Match Media Thickness"
[MOTOR ERROR TURN POWER OFF]
A motor error occurred.
Operation cannot be continued. Switch off the sub power. Next, eliminate the cause of the error, then im-
mediately switch on the sub power. If the machine is allowed to stand with the error uncorrected, the print
heads may dry out and become damaged.
This error may be caused by such factors as a mistake in loading the media, a media jam, or an operation that
pulls the media with excessive force.
The media has jammed.
Carefully remove the jammed media. The print heads may also be damaged. Perform the cleaning of the print
heads, then perform a printing test and check the results.
The media was pulled with excessive force.
Excessive tension was applied to the media, and additional action is necessary to recover from this state. First,
raise the loading lever and adjust the media to create a small amount of slack, then switch on the sub power.
[PINCHROLL ERROR LOWER PINCHROLL]
The loading lever was raised during the initialization or after the media has been loaded.
The error is cleared automatically after a short wait. Load the media correctly again.
[WRONG HEAD IS INSTALLED]
6
A print head that cannot be used was installed.
Operation cannot be continued. Switch off the sub power and contact your authorized Roland DG Corp.
dealer or us.
121