Disassembling the tilt cylinder and
trim cylinders
1. Hold the power trim and tilt unit 1 in a
vise using aluminum plates a on both
sides.
2. Loosen the tilt cylinder end screw 2, and
then remove it.
WARNING
Make sure that the rams are fully
extended before removing the end screw.
Trim & tilt wrench: 90890-06548
3. Drain the fluid.
4. Loosen the trim cylinder end screws 3,
and then remove them.
60C5D11
Tilt cylinder and trim cylinder (F100B)
5. Drain the power trim and tilt fluid.
S60C7425
6. Install the trim cylinder end screws 4
and tighten them finger tight.
S60C7430
NOTE:
Cover the tilt cylinder with a clean cloth 5.
7. Remove the free piston 6.
WARNING
Never look into the tilt cylinder opening
because the free piston and power trim
and tilt fluid may be expelled out force-
fully.
Trim & tilt wrench: 90890-06548
1
2
S60C7435
3
4
5
6
7
8
9
7-32