Installing The Propeller Shaft Housing - Yamaha F100C Service Manual

LOWR
NOTE:
Install the drive shaft by lifting it up slightly,
then aligning it with the pinion and the spline
of the drive shaft.
Drive shaft holder 5 3:
490890-06519
Pinion nut holder 4: 90890-06505
Socket adapter 2 5: 90890-06507
Pinion nut:
93 N·m (9.3 kgf·m, 67 ft·lb)
4. Tighten the housing bolt.

Installing the propeller shaft housing

1. Install the washers 1 and propeller shaft
assembly 2 into the propeller shaft
housing assembly 3.
2. Apply grease to the new O-rings.
6-21
Lower unit
S60C6270
3. Install the original shim(s) 4 and propel-
ler shaft housing assembly 5 into the
lower case, and then install the straight
key 6, claw washer 7, and ring nut 8.
4. Tighten the nut to the specified torque.
NOTE:
Secure the ring nut by bending one tab a
into the slot in the ring nut and the other tabs
toward the propeller shaft housing assembly.
Ring nut wrench 3 9: 90890-06511
Ring nut wrench extension 0:
90890-06513
Ring nut 8:
103 N·m (10.3 kgf·m, 74 ft·lb)
60C5D11