Yamaha F100C Service Manual page 284

BRKT
8. Install the filter H and plate I to the trim
cylinder.
9. Install the backup ring J and O-ring K
into the tilt piston L.
10. Install balls M and N, the absorber valve
pin O, springs P, pins Q and R, and
washer S into the tilt piston.
11. Hold the tilt ram end in a vise using alu-
minum plates on both sides.
12. Install the tilt piston to the tilt ram by
installing the bolt T, then tightening it to
the specified torque.
7-77
Bracket unit
S60C7875
Tilt piston T:
85 N·m (8.5 kgf·m, 61 ft·lb)
13. Install the trim cylinder onto the tilt ram.
14. Hold the trim cylinder G in a vise using
aluminum plates a on both sides.
NOTE:
Place the trim cylinder in the vise horizon-
tally.
15. Install the trim cylinder end screw 8, and
then tighten it to the specified torque.
CAUTION:
Do not damage the check valve b when
tightening the end screw.
Cylinder-end screw wrench:
90890-06544
60C5D11