Disassembling The Power Trim And Tilt Motor - Yamaha F100C Service Manual

Disassembling the power trim and
tilt motor
1. Remove the PTT motor screws.
2. Remove the lead holder 1 and spacer
2 from the yoke 3, and then slide them
towards the leads.
CAUTION:
• Keep the PTT motor leads inside the
yoke.
• Do not allow grease or oil to contact the
commutator.
NOTE:
Place a clean cloth over the end of the arma-
ture shaft and carefully pull the armature from
the yoke with a pair of pliers as shown.
3. Remove the screws 4, disconnect the
PTT motor leads 5, and then remove
the brush holders 6 and brushes 7.
60C5D11
Power trim and tilt motor (F100B)
CAUTION:
Do not touch the bimetal a, otherwise the
operation of the breaker may be affected.
NOTE:
Hold the brush with a screwdriver as shown,
and then disconnect the PTT motor lead
(blue).
S60C7640
1
2
3
4
5
6
7
8
9
7-44