Error During Stitch Generation - Pfaff 3586-2/02 Instruction Manual

14

Error during stitch generation

.02.04
If an error occurs during the calculation of the stitch data, operation is interrupted and an
error message displayed. The error message appears in clear text and if necessary with a
number in brackets. This number indicates the section, where the error has occurred.
Additionally errors may occur which have not been assigned a special text.
The meaning of the error number is shown in the following table:
Number
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
Error
No error
Wrong machine code in geometrical data record
Section clamp or section obstacle is missing or in the wrong place
Increment too large
Program end without trimming
Stitch length inadmissible
Wrong element in the geometrical record data
Fast slew although machine sewing
Stitch length inadmissible (line)
Stitch length inadmissible (circle)
Circle point = circle end point
Division by 0
Stitch length inadmissible (curve)
No coordinate section in front of the curve point
Sewing area exceeded
Curve without end point
Machine buffer functions full
Start sewing command in the loading position program
Wrong curve point
Wrong curve point
Wrong curve point
Wrong curve point
Stitch length not initialized
Load position program not finished
Stitch width command in the loading position program
Value not permissible for section stitch direction
Trimming command, although thread has been trimmed
Start sewing command, although machine is sewing
Trimming command in the Sewing-off area
Sewing-off command, although thread has been trimmed
Trimming command immediately after Start Sewing command
Control unit
14 - 14