Bias-Tape Binder; Multi-Stitch Gathering Attachment - Pfaff tiptronic 6232 Instruction Manual

A
~
""'"
,---...
~
prog
I
---
~
v
[a
G
2.5
0
0 3-5
Bias
tape
\b
G
2.5
0
- 3-5
binder
Bias-tape binder
Binding with a bias tape is a simple way of
lending fabric edges a smooth, neat appea-
rance. You will need: bias tape, 24 mm
wide, unfolded.
- Remove the presser foot and the sewing
foot holder and screw on the tape binder.
- Cut diagonally across the beginning of the
bias tape.
- Guide the tape into the scroll of the tape
binder and pull it out towards the back.
- Set the tape binder in such a way that the
needle perforates 1 - 1.5 mm from the fol-
ded bias-tape edge or adjust the need le
position .
- Sew a few cent imeters (about an inch)
along the bias tape before you insert the
edge to be bound into the slot of the tape
binder. The raw edge must be placed bet-
ween the bias tape edges. The bias tape
automatically encloses the raw edge during
the sewing operation.
Tip: You can achieve an additional effect by
using the zigzag stit ch or a fancy st itch .
A
~
""'"
,---...
~
prog
I
---
~
v
\ a G
3
0 0
3-5
Multi-
stitch
[b
G
3
0
-
3-5
~thering
a a chmen
MUlti-stitch gathering attachment
The classic sewing foot! You can make closely
or wide ly spaced pleats as if by magic. The
multi-stitch gathering attachment can be used
in three different ways:
1. Folding the fabric in pleats.
2. Folding the fabric in pleats and sewing
them simultaneously.
3 . Folding the fabric in pleats, sewing them
on and sewing lace onto them simultaneo-
usly.
When you buy your multi-stitch gathering
attachment at your PFAFF dealer, full opera-
ting instructions are included .
79