Pfaff 3586-2/02 Instruction Manual page 78

Input
2
3
4
5
6
Start sewing (number key 7)
With this function sewing is started. All following sections are sewn until the thread
trimming function is selected.
Thread trimming (number key 8)
The thread is cut. The sewing function must have been active beforehand.
Machine functions F2 (number key 9)
The machine functions are under this function. These can be displayed and selected via a
menu. All machine functions are allocated an adjustment parameter, with which it is possible
to move the function 99 stitches in front of or behind the current position.
11 - 38
STITCH LENGTH
A stitch length is defined for a certain seam sector.
STITCH WIDTH
With this function the carriage drive carries out a zigzag movement on a base line. The
stitch length specifies the movement along the base line from one penetration to the
next and has to be selected accordingly. The stitch width is performed perpendicular to
the base line. The position of the zigzag to the base line must also be defined. To
switch off the stitch width, enter the width as 0.0.
CIRCLE
To enter a circle, 3 points are required. The first point is automatically the starting point.
Both missing points must be entered. A stitch length must be defined.
ARC
For the arc the same applies as for the circle. The last point is the end of the arc.
CURVE END POINT
With this function a curve point is turned into a curve end point.
1 - INTERMITTENT FEED
2 - REDUCED SPEED
3 - SPEED
4 - PROGRAMMABLE OUTPUTS
5 - SEAM INTERRUPTIONS
1 2 3 4 5 6 7
Enter
8 9 0
Esc
Clear