Pfaff 3586-2/02 Instruction Manual page 74

Input
4
5
Pattern functions (number key 5)
1
2
3
11 - 34
1 - SCALE UP FACTOR FOR X - AXIS:
2 - SCALE UP FACTOR FOR Y - AXIS
3 - ROTATION ANGLE
4 - MIRROR
1 2 3 4 5 6 7
SCALE UP FACTOR FOR X - AXIS
1
This function is used to enlarge a block.
SCALE UP FACTOR FOR Y - AXIS
2
This function is used to reduce a block.
ROTATION ANGLE
3
This function is used to rotate a block.
The block is rotated anti-clockwise around the block starting point.
MIRROR
4
This function is used to mirror a block. The mirroring takes place on the straight
lines running parallel to the Y - axis and through the block starting point.
MOVE BLOCK
After selecting the MOVE BLOCK function, the carriage drive must be moved to a new
point. This point is taken over by pressing Enter, and the block is moved.
DELETE BLOCK
After selecting the function DELETE BLOCK, the block is deleted.
1 - MOVE PATTERN
2 - MANIPULATE PATTERN
(SYMMETRY POINT WITH TRANSFER KEYS)
3 - MANIPULATE PATTERN
(SYMMETRY POINT WITH NUMERIC KEYS)
1 2 3 4 5 6 7
MOVE PATTERN
After selecting the MOVE PATTERN function, the carriage drive must be moved to a
new point. The point is taken over by pressing Enter, , , , , and the pattern is moved from its
current position to the end of the program.
MANIPULATE PATTERN
(SYMMETRY POINT WITH TRANSFER KEYS)
By pressing transfer keys, the symmetry point is located (entered).
MANIPULATE PATTERN
(SYMMETRY POINT WITH NUMERIC KEYS)
The symmetry point is determined by entering coordinates with the number keys. Af-
ter the symmetry point has been entered, each of the functions SCALE UP FACTOR
FOR X - AXIS, SCALE UP FACTOR FOR Y - AXIS, ROTATION ANGLE and MIRROR are
available. For a description of the function compare MANIPULATE BLOCK. All the
functions apply to the entire program.
1.00
1.00
0°
OUT
8 9 0
.....
.....
Enter
8 9 0
Esc
Clear
Enter
Esc
Clear