Pfaff 3586-2/02 Instruction Manual page 53

SERVICE
5
This functions opens a menu for selecting the service functions:
1 - SEWING DRIVE FUNCTIONS
2 - STEPPING MOTOR FUNCTIONS
3 - DISPLAY INPUTS/OUTPUTS
4 - ADJUST ZERO POINT
5 - ADJUSTMENTS READ/WRITE
6 - OTHER FUNCTIONS
1 2 3 4 5 6 7
SEWING DRIVE FUNCTIONS
1
This function opens a menu for checking the sewing motor:
1 - TURN SEWING MOTOR
2 - THREAD TRIMMING PROCEDURE
3 - CUTTING SPEED - PRESELECT
1 2 3 4 5 6 7
Before activating the following functions, make sure that the
needle can enter the needle hole without any problem!
TURN SEWING MOTOR
1
With his function the sewing motor can be started and stopped again. The
speed can be pre - selected or even altered during running, using the plus/
minus keys.
THREAD TRIMMING PROCEDURE
2
This function starts the thread trimming procedure.
CUTTING SPEED - PRESELECT
3
This function preselects the positioning speed for thread cutting.
STEPPING MOTOR FUNCTIONS
2
This function opens a menu for moving the stepping motors:
1 - STEPPING MOTOR 1 (X)
2 - STEPPING MOTOR 2 (Y)
3 - STEPPING MOTOR 3 (D)
1 2 3 4 5 6 7
Before activating the following functions, make sure that the carriage
drive can move freely!
STEPPING MOTOR 1 (X)
1
This function moves stepping motor 1 (X - axis).
.....
.....
.....
.....
.....
Enter
8 9 0
200 RPM
8 9 0
8 9 0
Esc
Clear
Esc
Clear
Enter
Esc
Clear
Enter
Input
11 - 13