I/F (Interface) Mode; Flow; Table 7-1. Interface Mode Options; Table 7-2. Common Interface Mode Settings - Lantronix Ethernet User Manual

I/F (Interface) Mode

The Interface (I/F) Mode is a bit-coded byte entered in hexadecimal notation. The
default setting is 4C.
Note: RS-422 and RS-485 are available on Channel 2 only.
The following table displays available I/F Mode options:
Note: All bit positions in the table that are blank represent "don't care" bits for
that particular option; they can be set to either a 0 or 1 value.
I/F Mode Option
RS-232C
RS-422/485 4-wire
RS-485 2-wire
7 Bit
8 Bit
No Parity
Even Parity
Odd Parity
1 stop bit
2 stop bits
(1) 2 stop bits are implemented by the software. This might influence performance.
The following table demonstrates some common I/F Mode settings:
Common I/F Mode Setting
RS-232C, 8-bit, No Parity, 1 stop bit
RS-232C, 7-bit, Even Parity, 1 stop bit
RS-485 2-wire, 8-bit, No Parity, 1 stop bit
RS-422, 8-bit, Odd Parity, 1 stop bit

Flow

Flow control sets the local handshaking method for stopping serial input/output. The
default setting is 00.
WiBox2100E User Guide
I/F Mode (4C) ? _

Table 7-1. Interface Mode Options

7
(1)
0
(1)
1

Table 7-2. Common Interface Mode Settings

Setup Mode: Channel Configuration
6 5 4 3 2
1 0
1 1
0 0
1 1
0 1
1
1
Binary
0100 1100
0111 1000
0100 1111
0101 1101
1 0
0 0
0 1
1 1
Hex
4C
78
4F
5D
51