Table of Contents
Advertisement
MINUTO
Operational check - solenoid valves and pump
Start condition
Start condition
Press the ESPRESSO button to open the Electro Valve
Press the ESPRESSO button to open the Electro Valve
IMPORTANT NOTE: If the DREGDRAWER is not inserted or the DOOR is not
IMPORTANT NOTE: If the DREGDRAWER is not inserted or the DOOR is not
closed the EV test cannot be performed. If these 2 inputs are not in the
closed the EV test cannot be performed. If these 2 inputs are not in the
right position, a warning message will be shown and the display turns to
right position, a warning message will be shown and the display turns to
yellow.
yellow.
It is possible to hear the "click" from Electro Valve. The indication beside
It is possible to hear the "click" from Electro Valve. The indication beside
the EV1
the
EV1 changes from "OFF" to "ON".
changes from "OFF" to "ON".
Press the STEAM button to switch on the pump
Press the STEAM button to switch on the pump
The water goes out from the pipe and the indication IMP
The water goes out from the pipe and the indication
increasing numbers. The indication L/H must be within the range 10-18.
increasing numbers. The indication L/H must be within the range 10-18.
ERROR: The display backlight changes from green to red and the
ERROR:
The display backlight changes from green to red and the
impulse remains 0; If water comes out the pipe: check the wiring from the
impulse remains 0; If water comes out the pipe: check the wiring from the
fl owmeter to the CPU/POWER board (JP5). If no water comes out the pipe:
fl owmeter to the CPU/POWER board (JP5). If no water comes out the pipe:
check the pump and the wiring from the pump to the CPU/POWER board
check the pump and the wiring from the pump to the CPU/POWER board
(JP24).
(JP24).
ERROR: The L/H is zero or very low; the Electro Valve does not
ERROR:
The L/H is zero or very low; the Electro Valve does not
open. Check the wiring from the Electro Valve to the CPU/POWER
open. Check the wiring from the Electro Valve to the CPU/POWER
board (JP3) and the Electro Valve.
board (JP3) and the Electro Valve.
Press STAND_BY "
Press STAND_BY "
Operational check - coffee grinder and boiler
Initial status
Initial status
Press the STEAM button to switch on the grinder
Press the STEAM button to switch on the grinder
The grinder rotates and in the indication GRINDER the number
increasing up to 40. The other numbers inside the GRINDER box are not
important for this test.
ERROR: The number remains 0 or the grinder does not run, the
ERROR:
The number remains 0 or the grinder does not run, the
display backlight changes from green to red; check the Hall sensor
display backlight changes from green to red; check the Hall sensor
board of the Grinder, the Grinder, the wiring from the Hall sensor
board of the Grinder, the Grinder, the wiring from the Hall sensor
board to the CPU/POWER board (JP2) and the wiring from the
board to the CPU/POWER board (JP2) and the wiring from the
Grinder to the CPU/POWER board (JP8)
Grinder to the CPU/POWER board (JP8)
" to move to the next screen
" to move to the next screen
05 TROUBLESHOOTING
IMP shows
shows
Page
20
/ 46
Hide quick links:
Advertisement
Table of Contents
