Saeco Minuto Service Manual page 18

MINUTO
Machine ready signals (YELLOW colour)
The machine is heating up to
brew beverages or dispense
hot water/steam.
The machine is performing
the rinse cycle. Wait until the
machine has completed the
cycle.
The machine needs the
"INTENZA+" water fi lter to be
replaced.
The machine needs to be descaled. Press the "
process. Follow the steps described in the "Descaling" chapter of this manual.
If you want to descale later, press the "
Please note that not descaling your machine will ultimately make it stop
working properly. In this case repair is NOT covered under your warranty.
Machine ready signals (RED colour)
Completely insert the drip
tray with the coffee grounds
drawer into the machine
and close the service door.
Empty the coffee grounds
drawer. Wait about 5 seconds
before reinserting it.
Turn off the machine. After 30 seconds, turn it on again. Try this 2 or 3 times.
If the machine does not start, contact the Philips SAECO hotline in your country
and quote the error code shown on the display. The contact details can be found in
Exx
the warranty booklet packed separately or on www.philips.com/support.
03 USER INSTRUCTIONS
The brew group is being reset
due to machine reset.
Refi ll the coffee bean hopper
with coffee beans and restart
the cycle.
The machine automatically
primes the water circuit.
" button to start the descaling
" button to continue using the machine.
Fill the coffee bean hopper and
refi t the lid.
The brew group must be inserted
into the machine.
Fill the water tank.
Page 02 / 13