Subaru Forester EyeSight 2015 Owner's Manual page 32

Adaptive Cruise Control
How to use Adaptive Cruise Control
The Adaptive Cruise Control can be used while the engine is running.
■ Setting the Adaptive Cruise Control
(1) Setting Adaptive Cruise Control to standby status
Press the (CRUISE) switch. The Adaptive Cruise Control will be turned on and
(Adaptive Cruise Control) and
EyeSight indicator section located in the meter.
The trip meter switches to the set vehicle speed display and "- - - MPH (USA) or km/h
(Canada)" will be displayed.
If the switch is pressed once more, the EyeSight display will turn off. It will also automatically
turn off when the engine is stopped.
When all of the following conditions are met, the Adaptive Cruise Control can be set and the
"READY" indicator will be displayed on the EyeSight indicator section.
All doors including the driver's door, passenger's door and rear doors are closed.
The driver's seatbelt is fastened.
The parking brake is released (the brake warning light goes off).
The select lever is in the "D" position, and "D" is displayed on the combination meter.
The brake pedal is not depressed.
EyeSight operation is not temporarily stopped.
* Refer to page 71.
The road is not a steep slope.
The steering wheel has not been turned significantly in either direction.
Vehicle Dynamics Control was not turned off (the VDC OFF indicator light goes off).
The X mode is not turned on (the X mode indicator light
The vehicle speed is over approximately 25 MPH (40 km/h).
The vehicle speed is approximately 25 MPH (40 km/h) or less and there is a vehicle in
front.
28
(following distance setting) will be displayed on the
S00815
EyeSight
display
READY display
MPH
miles
goes off).
S00886