Setting; Network; Selecting Dhcp Or Static Ip Address (Tcp/Ip) - FLIR M3200 SERIES Instruction Manual

17 Using the Main Menu

17.3 Setting

The Setting menu allows you to configure general system, schedule, network, recording,
display, and motion settings. It also allows you to restore the system to factory defaults.

17.3.1 Network

The Network menu allows you to configure network parameters for your system.

17.3.2 Selecting DHCP or Static IP Address (TCP/IP)

The TCP/IP menu allows you to configure IP address settings.
To configure IP address settings:
1. From the Main Menu, click
2. Check DHCP (recommended) to let the system automatically obtain an IP address
from the router or uncheck to assign a static IP address.
If you uncheck DHCP, configure the following:
• IP Address: Enter the IP address you would like to assign to the system. Make sure
that no other device on your network is using the same IP address.
• Subnet Mask: Enter the subnet mask for your network.
• Default Gateway: Enter the gateway address for your network.
• Preferred DNS: Enter the address of your primary DNS server.
• Alternate DNS: Enter the address of your secondary DNS server.
3. Click OK to save changes.
#LX400051; r. 1.0/23100/23101; en-US
and then select Network>TCP/IP.
53