Lancom 3550 Wireless User Manual page 20

LANCOM 3550 Wireless
Chapter 2: Installation
Flashing Power-LED but no connection?
There's no need to worry if the Power-LED blinks red and you can no
longer connect to the WAN.This simply indicates that a preset time or
connect-charge limit has been reached.
There are three methods available for unlocking:
Reset connect charge protection.
Increase the limit that has been reached.
Completely deactivate the lock that has been triggered (set limit
to '0').
If a time or connect charge limit has been reached, you will be notified in LANmonitor. To
reset the connect charge protection, select Reset Charge and Time Limits in the context
menu (right mouse click). You can configure the connect charge settings in LANconfig under
Management Costs (you will only be able to access this configuration if 'Complete con-
figuration display' is selected under Extras
You will find the connect charge protection reset in WEBconfig and all parameters under
Expert Configuration
Wireless Link Gives information about the Wireless LAN access of the internal wireless net-
work adapter of the base station. The condition of the optional second exter-
nal wireless network card is not indicated on this display.
The wireless link display can assume four different conditions:
off
green
green
red
20
circumstances, you would assign a configuration password during the
basic configuration (see instructions in the following chapter).
Options...).
Setup Charges- module
blinking
flashing
no Wireless LAN adapter found
Wireless LAN adapter ready for use
activity in the Wireless LAN (blink frequency indicates
the number of registered stations)
error in Wireless LAN (e.g. sending error because of bad
connection)
Signal for reached time
or connect-charge
limit