Installing Dimms; Hard Drive Options - HP ProLiant DL320 Generation 5p User Manual

The following table lists some, but not all, possible configurations. For best performance, HP recommends
dual-bank interleaved mode configurations.
Slot 1A
512 MB
512 MB
1 GB
1 GB
1 GB
2 GB

Installing DIMMs

Power down the server (on page 20).
1.
Remove the server from the rack (on page 20).
2.
Remove the primary access panel (on page 21).
3.
Open the DIMM slot latches.
4.
Install the DIMM.
5.
Install the access panel.
6.
Install the server into the rack.
7.

Hard drive options

The server provides non-hot plug capability through an embedded SATA controller. To obtain hot-plug
capability, install an optional controller and hot-plug cable option kit.
Slot 2B Slot 3A
— —
— 512 MB
— —
— 1 GB
1 GB 1 GB
2 GB 2 GB
Slot 4B Total memory
— 512 MB
— 1 GB
— 1 GB
— 2 GB
1 GB 4 GB
2 GB 8 GB
Mode
Single-bank
Single-bank interleaved
Single-bank
Single-bank interleaved
Dual-bank interleaved
Dual-bank interleaved
Hardware options installation 31