Route and connect the hard drive cables to the backplanes and to the system board.
11.
Connect the power cables to the backplanes.
12.
Connect the front panel LED cable and the front USB cable to the system board.
13.
Install the secondary access panel.
14.
Install the primary access panel.
15.
Install the server into the rack.
16.
Optical drive assembly (12.7 mm) option
To install a 12.7-mm optical drive, a server model with the two-bay hard drive cage is required.
To install the component:
Power down the server (on page 20).
1.
Remove the server from the rack (on page 20).
2.
Remove the primary access panel (on page 21).
3.
Remove the secondary access panel (on page 21).
4.
Hardware options installation 36