Shoe Hardware; Carburetor Adjustments - Wacker Neuson BS 60-2 Operator's Manual

BS 60/BS 70-2
5.5

Shoe Hardware

See Graphic: wc_gr000055
5.6

Carburetor Adjustments

See Graphic: wc_gr004670
5.6.1
5.6.2
On new machines, or after replacing shoe, check and tighten shoe
hardware (a) after the first 5 hours of operation. Inspect hardware
every week thereafter.
Torque hardware as specified.
Refer to Technical Data for correct idle and operating rpm. For best
accuracy, use a tachometer when making carburetor adjustments.
Start engine and allow it to warm up to operating temperature.
Set engine idle speed with engine running at idle and choke (a) fully
open. Adjust idle speed screw (b), in or out, to obtain correct idle
speed.
NOTICE: DO NOT turn the adjusting screw in too tight or you may
damage the carburetor.
b
a
wc_gr004670
32
Maintenance