Table of Contents
Advertisement
ascade
C
Determine the most practical under-the-sink location for placement of the Cascade manifold unit. Ensure that the specific
location allows adequate access to the manifold unit for cartridge re placement.
1. Place the manifold in the selected location. If desired, the #6 self tapping screws may be used to secure the manifold
unit in position by means of the top rear and bottom lip mounting holes.
2. Route the blue tubing from the faucet assembly to the blue coded connector, marked Feed, on the top of the manifold
unit.
3. Take the green tubing already connected to the water feed valve and insert it into the green coded connec tor. Push the
tubing approximately 1/2" into the connector until fully seated.
4. Affix Shutoff Warning to the manifold unit so that it is directly visible in the event that a cartridge is to be replaced. The
Cascade Drinking Water Filtration system is now connected and ready for system activation.
TUBING HINTS: Use a sharp knife or tubing cutter to cut the tub-
ing squarely, being sure to remove all burrs. Then insert the tubing
firmly until it stops. To remove the tubing, push against the collet
while pulling on the tubing.
Fig. 3
8
Manifold Installation
Fig. 4
42445 Avenida Alavardo, Temecula, CA 92590
(800) 451-9343, www.nimbuswater.com
Fig. 5
7
Fig. 6
Advertisement
Table of Contents
