Sony SAL135F18Z Service Manual page 32

HELP19
1. After removing the tilt adjustment washers, they should reinstall the replaced positions.
Note:
After replacing the lens block 4, install the three tilt adjustment washers D (0.1mm) as shown in figure.
2. Install the 4 lens block, aligning it with positioning pins at three locations of length grove barrel assy. Then, tighten three screws to
fix the 4 lens block.
Tilt Adjustment Washer D
Positioning Pins
HELP20
Adhesive bond (B-10): J-6082-612-A
Special driver:
1. Affix the focus scale to meet the length grove barrel assy (vertical, horizontal).
Note:
• Confirm that the focus scale is not floated.
• Confirm that the surface of focus scale is clean.
2. Expose both ends of focus scale by peeling off the protection tape so that screws can be tightened.
3. Fix the focus scale with two screws. (Use the special driver: J-6082-654-A)
4. Apply the adhesive bond (B-10) to the heads of screws.
Screws
(Apply the adhesive bond (B-10))
SAL135F18Z (Sonnar 1.8/135 ZA) (Sonnar T
Screws
J-6082-654-A
Pasted standard Vertical
Pasted standard Horizontal
135mm F1.8 ZA)
*
4 Lens Block
Tilt Adjustment Washer D
Positioning Pins
Length Grove Barrel Assy
Positionaing Pins
Length Grove Barrel Assy
Focus Scale
HELP