Display Assembly Subcomponents - HP Pavilion 17 Maintenance And Service Manual

5. Remove the TouchPad button board (4).
Reverse this procedure to install the TouchPad button board.

Display assembly subcomponents

NOTE: The display assembly is spared only at the subcomponent level. For more display assembly
spare part information, see the individual removal subsections.
To remove the display assembly and access the display assembly subcomponents, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Optical drive (see
b. Hard drive (see
c. WLAN module (see
d. Keyboard (see
e. Top cover (see
Remove the display assembly:
1. Disconnect the display panel cable (1) from the system board.
2. Release the display panel cable from the clips built into the base enclosure (2).
Battery on page 46), and then remove the following components:
Optical drive on page
Hard drive on page 48)
WLAN module on page
Keyboard on page 56)
Top cover on page 60)
47)
51)
Component replacement procedures
65