Fujitsu AU*G36LRLA Design & Technical Manual page 295

FUNCTION SETTING
„ „
3) Pressing the SET TEMP. p button or SET TEMP. q button, select a remote controller
address (select the indoor unit you want to operate).
4) Press the FAN button so that the "Function number" display flashes. Then, press either the
SET TEMP. p button or the SET TEMP. q button to set up the function number.
5) Press the FAN button so that the "Setting number" display flashes. Then, press either the
SET TEMP. p button or the SET TEMP. q button to set up the setting number.
6) Pressing the START/STOP button, confirm the setting.
(The data will be transferred to the indoor unit.)
● When the data was not set up on the indoor
unit (-- is displayed.)
● Set up the data again according to the
procedure in step 4), 5) above.
FUNCTION DETAILS
„ „
Refer to 6-6. FUNCTION DETAILS
Remote controller address
Ex.) When remote controller address "00" is selected
Function number
Setting number
Ex.) Function number : 30, Setting number : 01
GOOD
ERROR
When the data was normally set up on the indoor
unit.
- (05-66) -