Fujitsu AU*G36LRLA Design & Technical Manual page 281

SWITCHING SELECTION OF FUNCTION SETTING MODE
„ „
(2) Press and hold the "FAN" and the " SET TEMP.
press the "RESET" button.
SELECTION AND CONFIRMATION OF SIGNAL CODE
„ „
(3) Press the " SET TEMP.
TEMP. " buttons to select the signal code
q
that matches the setting with the indoor
unit. By selecting the appropriate signal
code, the communication between the
indoor unit and the wireless RC become
possible.
SIGNAL CODE
( - - - )
The initial setting is " "
FAN
SET TEMP. ( )
RESET
" or " SET
p
- (05-52) -
" buttons. While holding these 2 buttons,
p
Function setting
mode display
(4) Press the "TIMER MODE" button to send
the code to the indoor unit.
Pi Pi