Transferring Ink Volume - MUTOH Spitfire 65 Operation Instructions Manual

3.6.3 Transferring ink volume

Via the smart chip reader slot
Please follow the instructions below to transfer the ink volume on the SmartChips to the SmartChip
Management System.
Browse to the ChipStatus menu and press the F1 key.
Step 1 :
Notes
Be sure to be in printer mode, otherwise "ChipStatus" will be replaced by "InkStatus".
Insert the SmartChip in the reader slot and press the ENTER key.
Step 2 :
The system will scan the reader slot.
Step 3 :
Perform the correct action based on the displayed message.
Step 4 :
the total printer chip value exceeds 40 000 ml
IF...
a cleaning card is detected
a valid card is found
no valid card is found
Operation Instructions Spitfire 65/90 Extreme
►
Remove the SmartChip card and
Press ENTER to transfer the ink volume
Press CANCEL to quit the operation
Remove the SmartChip card. You will be
asked if you want to scan the cartridge slots
Please refer to the next chapter for all the
The transfer has been cancelled
33
CHAPTER 3 : BASICS
THEN...
press ENTER
for ink volume.
details.
automatically.
AP-77140 – Rev. 1.1 – 05/04/07