Motor Protecting Switch; High Pressure Hose And Spray Device; Total Stop System - Kranzle 2160 TS Operating Manual

Motor protection switch
The motor is protected from overload by a motor protection switch, which cuts out the
motor in the event of overload. However should the switch trip frequently, the cause of
the malfunction should be located and rectified (see page 11).
Replacements and inspection work should only be performed
by qualified persons when the machine is disconnected from
the power supply, i.e. with plug pulled out from the electrical
socket.

High pressure hose and spray device

The high pressure hose and spraying device supplied with the machine are made of high
grade material, they are also optimised for the machine and marked as required by the
appropriate regulations.
If replacement parts are required, only such parts that are
authorised by the manufacturer and which bear the markings
required by the appropriate regulations may be used. The
high pressure hose and spray device must be connected in
a pressure-tight manner. The high pressure hose may not be
driven over, pulled excessively, or twisted. The hose may under
no circumstances be pulled over sharp edges, since otherwise
the guarantee is automatically void.

Total stop system

The new Kränzle K2160 / K2195 / K2175 are equipped with an electrical Start/Stop
control. Having connected the high-pressure cleaner to the water supply and having
connected the HP hose, switch the machine "on" using the On/Off switch. A red light in
the switch flashes.
The motor is started by opening the gun. The motor is switched off after the gun has
been closed. The high-pressure cleaner works in stand-by until the On/Off switch is
switched to "Off". The red light in the switch goes out.
Having switched off the machine shortly press the trigger to release the pressure to be
able to unfasten the HP hose.
13