General Specifications; Fuse Replacement - Brymen TBM811 User Manual

17
access door and thus the battery compartment up. Replace the battery. Re-fasten the
screws.

Fuse replacement:

Loosen the 4 screws from the case bottom. Lift the end of the case bottom nearest the input
jacks until it unsnaps from the case top. Replace the blown fuse(s). Replace the case
bottom, and ensure that all the gaskets are properly seated and the two snaps on the case
top (near the LCD side) are engaged. Re-fasten the screws.

GENERAL SPECIFICATIONS

Display:
9999 counts: ACV, DCV, Hz & nS
6000 counts: mV, A, mA, A, Ohm & Capacitance
Polarity: Automatic
Update Rate:
Digital Display: 5 per second nominal;
41 Segments Bar-graph: 60 per second max
Low Battery: Below approx. 7V
Operating Temperature: 0 C to 45 C
o o
Relative Humidity: Maximum relative humidity 80% for temperature up to 31 C decreasing
o
linearly to 50% relative humidity at 45 C
o
Pollution degree: 2