Treadmill: Adjusting The Running Belt - Precor 954i Owner's Manual

5. Press the SPEED up key until the display shows a speed of 3 mph
(5 kph).
CAUTION: If you hear any chafing or the running belt
appears to be getting damaged, stop the running belt
immediately by pressing the red STOP button. Contact
Precor Customer Support.
6. Walk around to the rear of the equipment and observe the belt
for a few minutes. The belt should run centered along the running
bed. If the belt drifts off center, you must make adjustments. Refer
to Treadmill: Adjusting the Running Belt.
Important: Failure to align the belt may cause the belt to tear or
fray, which is not covered by the Precor Limited Warranty.
7. To stop the running belt, press the red STOP button.
8. Turn the treadmill Off.

Treadmill: Adjusting the Running Belt

If you are unsure about adjusting the running belt, call Precor
Customer Support (refer to Obtaining Service).
CAUTION: For your safety, use the power switch to turn Off the
treadmill before making any adjustments. Do not adjust the
running belt when someone is standing on the equipment.
1. Locate the right belt adjustment bolt in the rear end cap of the
treadmill. Refer to Diagram 4.
Product Owner's Manual: Maintenance
Diagram 4: Location of the adjustment bolt
To determine left and right, stand at the rear of the treadmill and
face the display. Make all belt adjustments on the right rear corner
bolt using the hex key provided.
• If the belt is off center to the LEFT, turn the adjusting bolt ¼ turn
counterclockwise, which moves the running belt to the right.
• If the belt tracks off center to the RIGHT, turn the bolt ¼ turn
clockwise; this moves the belt to the left.
Important: Do not turn the adjusting bolt more than ¼ turn at a
time. Overtightening the bolt can damage the treadmill.
2. Recheck the alignment of the running belt by repeating the steps
found in Treadmill: Checking the Alignment of the Running Belt.
28