Efx: Cleaning The Ramp; Storing The Chest Strap; Treadmill: Checking The Alignment Of The Running Belt - Precor 954i Owner's Manual

EFX: Cleaning the Ramp

Whenever the ramp becomes soiled, clean the exposed surfaces of
the ramp and roller wheels by taking the following steps.
Note: If your equipment has a ramp cover, remove it before performing
the following steps. Refer to the EFX Assembly Guide.
1. Moisten a clean, soft cloth in a mild solution of soap and water.
2. Position one foot pedal at the top of the ramp (the other will
automatically be positioned at the bottom).
3. Clean the exposed portions of the ramp.
4. Gently lift the roller wheels. Rotate each wheel while wiping it with
the clean, soft cloth.
5. Switch the foot pedal position and finish cleaning the ramp.

Storing the Chest Strap

If you purchased the optional heart rate chest strap, store it in a place
where it remains free of dust and dirt (for example, in a closet or
drawer). Be sure to protect the chest strap from extremes in
temperature. Do not store it in a place that may be exposed to
temperatures below 32° F (0° C).
To clean the chest strap, use a sponge or soft cloth dampened in mild
soap and water. Dry the surface thoroughly with a clean towel.
Product Owner's Manual: Maintenance
Treadmill: Checking the Alignment of
the Running Belt
Proper belt alignment allows the belt to remain centered and ensures
smooth operation. Realigning the belt takes a few simple adjustments.
If you are unsure about this procedure, call Precor Customer Support.
Refer to Obtaining Service.
CAUTION: Special care must be taken when aligning the
running belt. Turn Off the treadmill while adjusting or working
near the rear roller. Remove any loose clothing and tie back your
hair. Be very careful to keep your fingers and any other object
clear of the belt and rollers, especially in front of the roller and
behind the deck. The treadmill will not stop immediately if an
object becomes caught in the belt or rollers.
1. Make sure that the running surface is level. To operate correctly,
the treadmill needs to be as level as possible. If needed, the rear
feet can be adjusted to level the treadmill (refer to the Assembly
Guide). However, if the treadmill is placed on an uneven surface,
adjusting the rear feet can help but not compensate for extremely
uneven surfaces.
2. Turn the equipment On.
3. Stand beside the treadmill and press QUICKSTART.
4. If needed, enter the safety code by pressing the number keys in
sequence: 1, 2, 3, 4.
The running belt starts automatically after a 3-second countdown
appears on the display.
27